OKUMA E4809-436-016-D PCB卡
設置時間/日期：這些消息用于設置PQM軟件時鐘的時間和日期。PQM軟件時鐘保留約一小時的電源中斷?？梢詥⒂脮r鐘未設置警報，以便在時鐘數據丟失時發出警報。時間和日期用于所有帶時間戳的數據。如果尚未設置時鐘，則所有時間戳數據的顯示時間右側將顯示“？”。按照以下步驟設置新的時間和日期。時間和日期也可以通過Modbus通信設置。有關計算參數示例，請參閱第7.2.10節功能代碼16-廣播命令。PQM可編程為通過各種方法計算計量量和需求。XTRACT基本信息：PQM可被編程為使用真實RMS值或采樣數據的基本成分計算所有計量量。當該設定值設置為DISABLE（禁用）時，在進行計量計算時，PQM將包括所有諧波含量，最高32次諧波。
SET TIME/DATE: These messages are used to set the time and date for the PQM software clock. The PQM software clock is retained for power interruptions of approximately one hour. A CLOCK NOT SET alarm can be enabled so that an alarm will occur on the loss of clock data. The time and date are used for all time-stamped data. If the clock has not been set, a “?” will appear on the right-hand side of the displayed time for all time-stamped data. Follow the steps shown below to set the new time and date. The time and date can also be set via Modbus communications. Refer to section 7.2.10 FUNCTION CODE 16 - BROADCAST COMMAND for an example Calculation Parameters The PQM can be programmed to calculate metering quantities and demand by various methods.XTRACT FUNDAMENTAL: The PQM can be programmed to calculate all metering quantities using true RMS values or the fundamental component of the sampled data. When this setpoint is set to DISABLE, the PQM will include all harmonic content, up to the 32nd harmonic, when making metering calculations.
轉載請附上此鏈接：http://m.wzljsf.com/
