HARTING 09061487901模塊卡件
1.產 品 詳 情 資 料：
三個板載通信端口：–CN1+CN2（內置，10/100Mbit/s）以太網端口（IEEE 802.3u，10Base-T/100Base-Tx）。–用于維修工具的COM4（內置）串行端口（RS-232C）。?兩個冗余控制鏈路-RCU控制鏈路和RCU數據鏈路-用于冗余配置。?安全數字（SD）卡插槽，支持SD卡加載應用程序和循環保存冷保留值。支持各種制造商的SD卡。內存?16 MB閃存PROM（固件存儲）。?256 MB DDR2 SDRAM，帶完整性檢查。功耗15.8 W，典型值19.5 W（包括對ModuleBus和CEXBus的完全供電。電流消耗660 mA，典型值（最大值750 mA）（不包括對ModuleBus和CEX總線的供電）。電源輸入連接器四針螺紋連接器L+、L-、SA和SB。電源要求輸入指定為L+和L-24 V標稱電壓，在19.2 V DC和30 V DC之間變化。冗余電源狀態輸入指定為SA、SB的輸入?最大輸入電壓30 V?高電平的最小輸入電壓15 V?低電平的最大輸入電壓8 V這些是狀態輸入，閾值電平是輸入上邏輯“0”或“1”的限制，即不是電源故障限制。根據EN60529和IEC 529，儲能器5 ms防護等級IP20。重量1.6 kg（帶包裝1.9 kg）尺寸W 200 x H 186 x D 102 mm（7.9 x 7.3 x 4.0 in）寬度沿DIN導軌測量，距墻深度和垂直高度，包括鎖緊機構。
Three on-board communication ports: – CN1 + CN2 (built in, 10/100Mbit/s) Ethernet ports (IEEE 802.3u, 10 Base-T/100Base-Tx). – COM4 (built in) serial port (RS-232C) for service tool. ? Two Redundancy Control Links — RCU Control Link and RCU Data Link — for use in redundant configuration. ? Secure Digital (SD) card slot that supports the SD card for loading of application and for saving the cold retain values cyclically. The SD cards of various manufacturers are supported.Memory ? 16 MB flash PROM (firmware storage). ? 256 MB of DDR2 SDRAM with integrity check. Power Dissipation 15.8 W typical 19.5 W typical (incl. full supply to ModuleBus and CEXBus. Current Consumption 660 mA typical (750 mA max.) (excl. supply of ModuleBus and CEX-Bus). Power Input Connector Four pin, screw connector L+, L–, SA and SB. Power Supply Requirements Inputs designated L+ and L– 24 V nominal, variation between 19.2 V DC and 30 V DC. Redundant Power Supply Status Inputs Inputs designated SA, SB ? Max input voltage 30 V ? Min. input voltage for high level 15 V ? Max input voltage for low level 8 V These are status inputs and the threshold levels are limits for logic "0" or "1" on the inputs, that is, not power fail limits. Power Reservoir 5 ms Protection Rating IP20 according to EN60529, IEC 529. Weight 1.6 kg (1.9 kg with package) Dimensions W 200 x H 186 x D 102 mm (7.9 x 7.3 x 4.0 in) Width is measured along the DIN-rail, depth from the wall, and height vertically, including lock mechanism.
2.產 品 展 示
3.公 司 優 勢 主 營 產 品
4.相 關 產 品 展 示
本篇文章出自瑞昌明盛自動化設備有限公司官網，轉載請附上此鏈接:http://m.wzljsf.com
